Photo: THE TREE OF HOPE. Argithea Karditsa Greece
by Chrysanthos Maroulis
GENERAL INFORMATION & TECHNICAL SPECIFICATIONS
THE PRODUCTS ARE MANUFACTURED IN GREECE
- 220V~50 Hz
- Class 1
- G9 lamp socket
- The light fixture is not intended for looped-in wiring
- The light fixture is intended to be connected to fixed wiring
- We use a double-sleeved rubber cable to connect the H05RN-F 3G1.5 light fixture
- The light fixture does not include a power connection cable.
GENERAL SAFETY INFORMATION
- Before any work is carried out, the power supply must be switched off
- Installation must only be carried out by a licensed electrician with knowledge of the Rules on Internal and External Installations in force
- If the glass breaks, please replace it immediately
- Do not exceed the number of watts (W) indicated on the light fixture
- The lamp wattage must not be greater than the power indicated on the label on the light fixture or on the packaging
- The product must be connected to a line with a differential current protection and a nominal residual operating current that does not exceed 30ma (earth leakage relay)
The package contains:
1 plastic protective cover for the lampholder (socket)
3 sets of anchors – screws for wall mounting
3 plastic tubes for additional protection of the power cables
INSTALLATION OF THE LIGHT FIXTURE
A. MOUNTING THE LIGHT ON A SUPPORT SURFACE
- Remove the light fixture’s mesh and socket by unscrewing the decorative screws on the mesh
- Mark the surface on which you will be mounting the light fixture
- Drill holes into the support surface and place the anchors
- Tighten the base of the light fixture’s body with the screws
B. CONNECTING THE POWER SUPPLY CABLES
- Remove the socket with the terminal strip from the base of the light fixture’s body
- Pass the power cord through the shaft seal
- Connect the phase and neutral (brown – blue) lines to the porcelain terminal strip marked L&N respectively, after covering the wires with a protective plastic tube
- The yellow – green insulation (earth) wire is connected to the base of the light fixture with the M4 screw and washer, in the area marked by the earth symbol
- Place the socket with the terminal strip at the base of the light fixture’s body
- With a spanner, tighten the shaft seal to ensure that the cable is properly held and that the light fixture is sealed
- Place the lamp in the lampholder
- Place the glass with the rubber gasket and mesh and carefully screw them in order to ensure the light fixture’s sealing
- Supply power to the light fixture to turn it on
LAMP REPLACEMENT INSTRUCTIONS
- Switch off the power
- Do not attempt to replace the lamp until it has cooled down completely, as it may cause burns
- Open the lamp access cover
- Do not touch the lamp with bare hands
- Always use clean protective gloves when handling the lamp
- Use a clean towel to clean the lamp if accidentally touched
- When changing the lamp, please rotate or pull the lamp in the socket carefully
- Replace the cover before restoring the power supply to the lamp, in order to ensure the light fixtures’ seal.
The manufacturer accepts no liability for any injury or damage caused by incorrect placement or use of the product
Visit our store
– European online shop: techtube.eu
– International online shop: Brass-Light-Fixtures.com
1 Comment for “Outdoor brass light fixtures, TYPE: ART BR434. Instructions for use and installation”